New PowerEdge packs punch
Ninth-generation Dell server steps up the speed, storage, and serviceabilityFollow @pvenezia
Dell’s PowerEdge server line is nearly a decade old, and the newest examples bear little more than a passing resemblance to their ancestors. The Dell PowerEdge 2950 I’ve been running in my lab presents a sleek, spare, and completely tool-less chassis; it also packs a bigger punch than its predecessors.
This generation overcomes more than a few shortcomings common to the PowerEdge line, at least in the 2U, dual-processor rack-mount products such as the 2950. The new crop is much quieter than earlier models and easier to open and service. As for the internals, the highlights are new CPUs, SAS storage options, and stronger remote management capabilities.
The new PowerEdges leave straight SCSI drives behind, opting for either 2.5-inch or 3.5-inch SAS drives in capacities of as much as 300GB, or SATA disks as large as 500GB. With a choice of four, six, or eight hot-swap bays depending on drive size, this equals 1.8TB to 2.5TB in raw storage per server. Driving all that disk is either a non-RAID SAS controller or the new PERC (PowerEdge Expandable RAID Controller) 5/i SAS RAID controller. A slim-line DVD-ROM and a floppy drive are also included.
On the other side of the I/O channel is the dual Broadcom NetXtreme II Gigabit NICs with TOE (TCP Offload Engine). Right in the middle are eight DIMM sockets, handling as much as 32GB of RAM and providing spare banks to handle a RAM failure. The power supplies are 750 watts each.
The 2950 I was shipped came with 4GB of RAM, four 15,000-rpm 72GB SAS drives with the PERC 5/i, and two dual-core 3.0GHz Intel Xeon EM64T (aka Woodcrest) CPUs. Along with support for a 1,333MHz front-side bus, these CPUs have 4MB of L2 cache on die, and the snappy performance shows it.
Inside the box
When I first fired up the PowerEdge 2950, it wouldn’t boot. Lacking even a POST screen, the handy LCD display on the front signaled an error with one of the CPUs. I popped the top to see whether anything had unseated during shipping. The interior of the 2950 is nicely organized, lacking in large baffles, and sporting surprisingly few fans. All of the components are easily accessible and even color-coded. Orange handles signify parts that are hot-swappable, such as the fans, and blue handles denote those that are not.
After checking the RAM, I pulled out the fan sets and then the CPU heat sinks. The heat sinks are constructed in such a way as to fit together like puzzle pieces, with the main cooling fans blowing right across the fins. Removing and reseating the fans, heat sinks, and processors took only a few minutes, although I wasn’t so enamored with the cover-locking mechanism on the top of the case, which doesn’t work as well as a similar setup found in Hewlett-Packard’s ProLiant DL products. In any event, reseating the CPUs did the trick; the 2950 fired right up. Aside from this initial hurdle, the 2950 has performed flawlessly in the lab in the weeks since.
Longtime users of Dell servers can attest that the older models — particularly the seventh generation — were quite loud, even under little or no load. Dell eventually released firmware updates that brought the fan speed down to limit the noise. The 2950 doesn’t suffer from this particular affliction, and it fit into the overall hum of the lab well. The small number of fans and the new case layout helps significantly.
PERC, DRAC, and perk